Back to Blog
Corellaser 2013.025/25/2023 ![]() Since this cloned disk wasnt exactly compatible with the laptop, half the drivers were missing or not working, including the network drivers. Good sign I didnt want to take a risk so instead of installing on the laptop as is, I grabbed a spare hard disk, which was cloned from another laptop, and installed everything on that (removing the laptops original hard drive). The burned DVD you get has all the bits you need.įunnily enough my virus checker detected that one of the executables ( UKey.exe ) there had a trojan virus. Make sure you dont lose it or you wont be able to operate the cutter. ![]() What it is is a decryption key thats required to run the dodgy CorelLaser software you need to install. Remember that orange USB stick from the first part of the post Well thats not flash memory, in fact when you plug it in it simply registers as USBkey. I had to apply pressure on the board to plug the cable in, it works way, but there is tension on the socket which may cause it to break in time. ![]() You can see in the photo below that the hole cut out for the USB plug doesnt actually line up with the socket. ![]() The provided USB cable plugs into the cutters electronics and then into your computer. Please do not contact me asking if I have the software that came with this cutter - I dont, and even if I did I would not share it because the software appears to have been pirated by the Chinese distributors.
0 Comments
Read More
Leave a Reply. |